to bring together separately

[galeottone]

Hello everyone! I am quite new to the forum and above all to sw.my question can be trivial but to me it ipedes to continue.I am doing a pretty complex design for which I had to mate several parts before the same was finished and here the parts were saved in sldasm.I have to continue the design, to use the command "divid" I should return to sldprt, but at this point I feel that I could lose all

 

[Oldwarper]

Hello everyone! I am quite new to the forum and above all to sw.my question can be trivial but to me it ipedes to continue.I am doing a pretty complex design for which I had to mate several parts before the same was finished and here the parts were saved in sldasm.I have to continue the design, to use the command "divid" I should return to sldprt, but at this point I feel that I could lose all

Hello, galeottone.

First of all, a presentation is welcome, in the appropriate section and as a regulation.

to use the analogue of "divids" in the context of together you can use the command "cavity" (to subtract one body to another) or "join" (to connect two parts), after selecting a part in the axieme through the "modification component" icon in the environment of together.

look at the help for the commands indicated for other information.

 

[galeottone]

Thank you so much! I have written the passages you have suggested to me and the result was excellent.I hope I can counter-change in other field because you will realize that in sw I am a "september". ..so at least they indicate in Tuscany those who have just begun a path.