tree shovel

[Marco_3D]

Hello to you,

I've been using inventor recently.
and by mistake I closed the top left of the controls
where there is the tree with all the skechs and feactures.
How can I reactivate it? ? ?

Thank you.

 

[stefanobruno]

How can I reactivate it? ? ?

dx button on " displays " --> tick on " command panel bar "

then go to the counter at the entrance and leave a brief presentation.

Bye.

 

[Marco_3D]

Good morning stefanobruno,

I am using inventor 2011 and I tried following
meticulously your advice, but the model shovel is not
managed to get her recomparison.

My version is the one in English, I even tried to translate
commands but without any positive result.
then I read the old posts and maybe the only possible solution would be
to reinstall the software.

if you have other advice will be well accepted.

Bye.

 

[Marco_3D]

thanks to all for your valuable advice

 

[Catafratto]

if I did not understand bad what you lost (called tree is indicated as browser) user-interface-> quit browser. now you may be present in the section (see the main page) ...