TECNOMODEL
Guest
I have a sketch of a loft that drives me crazy.
practically all are projected edges except a straight connecting two of them to close the curve.
every time I move the end starts above, when I bring it down, it gives me an unresolved geometry bond error.
always on the right of connection.
the helimin together with the two segments projected, I reproduce the same, I connect with the straight and everything is resolved.
But if I move the end part again I have to fix the sketch.
In addition, sometimes, it is not enough to do the procedure because it continues to give error.
I repeat it several times and magically one of these works.
suggestions?
practically all are projected edges except a straight connecting two of them to close the curve.
every time I move the end starts above, when I bring it down, it gives me an unresolved geometry bond error.
always on the right of connection.
the helimin together with the two segments projected, I reproduce the same, I connect with the straight and everything is resolved.
But if I move the end part again I have to fix the sketch.
In addition, sometimes, it is not enough to do the procedure because it continues to give error.
I repeat it several times and magically one of these works.
suggestions?