update library styles on multiple idw

[Ilario]

Hello, everyone.

As from title, do you think there is a way to update the style library on multiple idw without having to open one by one?
as you may do in a joint when you check out the item "update styles in all derivative documents" to mean, or similarly. . .

Thank you.

 

[pierluca]

Hi, Ilario,
If I understand correctly you intend to transfer the data you have in a table on multiple target idw.
I use, among the tools of inventor, drawing resource tranfer wizard.
select your source idw and then choose which properties to transfer to your files.
I hope you'll be useful and that's what you mean.

Good job

 

[Ilario]

Thanks, but I think you mean that tool that "transports" resources drawing (folds, edges, symbols, etc...) from an idw to others... instead I need to update the styles of more idw by updating them from the style library, which is another thing.

Thanks anyway.

 

[cen82]

Thanks, but I think you mean that tool that "transports" resources drawing (folds, edges, symbols, etc...) from an idw to others... instead I need to update the styles of more idw by updating them from the style library, which is another thing.

Thanks anyway.

Ilario, did you find what you were looking for? because I care a lot too

 

[Ilario]

Unfortunately, no...

 

[Catafratto]

I speak for inventor 2014
under additional modules I have a batch update styles that if I didn't get it wrong does what you need, you can select a group of idw. I don't remember installing it, so you should have it too... But I can remember badly.

 

[Ilario]

ah, yes, I didn't remember.... I used it in fact, but then I removed it from having installed it
is part of the sdk

 

[Tarkus]

bho, I don't have it on 2015

 

[Ilario]

you have to install it, it is among the sdk setups, I don't remember exactly but maybe you have to download from the autodesk site, it will create a folder in the pc with acune utilities to install including this.

 

[Ilario]

I take this discussion for another derived need. . .
someone of you knows if there can be a way to use this batch update styles in inventor operations programming?
type through a command line in a custom operation or through a kind of ilogic (the shot without knowing eh...).
this to be able to launch at night a global update of a scattered of drawings.. .