use command projects 3d elements and difficulty in closing geom profiles.

[opua]

save to all, when they are in sketch phase often using the command project elements 3d encounter difficulty in closing the profiles of the geometry. For example, if for construction needs I will have to copy the edges of some geometries created previously (then segments of yellow color that then won), despite paying much attention to clear the excess segments and use the constraints to do a clean job, I notice punctually by sketch analysis that there are several open profiles that do not allow to proceed with modeling. thinking that there was a few lines too much, I tried to rectify and monitor each segment built but, despite everything is ok geometry does not close! where am I wrong? I don't know how to move on anymore.
thanks 1000 to all

 

[fenice consulenze]

save to all, when they are in sketch phase often using the command project elements 3d encounter difficulty in closing the profiles of the geometry. For example, if for construction needs I will have to copy the edges of some geometries created previously (then segments of yellow color that then won), despite paying much attention to clear the excess segments and use the constraints to do a clean job, I notice punctually by sketch analysis that there are several open profiles that do not allow to proceed with modeling. thinking that there was a few lines too much, I tried to rectify and monitor each segment built but, despite everything is ok geometry does not close! where am I wrong? I don't know how to move on anymore.
thanks 1000 to all

hi, if I don't remember badly, there is a command that closes the geometry and if there were "useless" segments you can delete them physically.
if I'm not mistaken should be in the sketch analysis command.
test and update

 

[falonef]

hello can you post an example?

 

[Stefal639]

to me often happens, especially when I create fittings on the sketch and not later on the solid... leaves me pieces of segments, always and only on the second line I want to collect. . It also leaves me the points of the previous lines. ..through the sketch analysis is indicated where "there are anomalies", well read the description and if it tells you that there is a free line or non-built points press the rubber...you will see that everything is resolved...at least to me it always happened like this:tongue:

 

[fenice consulenze]

correct stefal, it was exactly the modus operandi that I remembered:finger: