use of basic pro-e symbols and creation of new

[Tekkasoft]

Bye to all,

Some of you know how to make symbols to use, for example, as an alternative to bubbles.
I tried to change the design of the standard one, creating a copy, but when imposed it as an alternative, references to the associated repetition region are lost.

exists, apart from the pro-e help, a tutorial on how to create/modify symbols and all its attributes?

thanks to all of the attention

 

[BerAnd]

Bye.
I created the bubble symbol like this:
- I generated a note with the word \asm.mbr.name\
- to the two extremes of the note I created two lines of 1 tenth
-In addition to the attributes I set sin guide and des guide taking the ends of the two lines created previously.

with this system the bubble obviously takes only the code of the region of distinct base, but if you want you can put so many others, such as name quantity etc...
that I know however there are no help in this regard...

I hope to have been clear, but above all useful
Hi.

 

[Tekkasoft]

very useful. . .
Thank you.
Hi.

 

[mgdi]

But it doesn't work for me!
I created the symbol with inside the note etc.etc. only that displays me exactly asm.mbr.name and not the name relative to the component!

Where am I wrong?

use wf5 (cree elem. pro5)

Thank you.

 

[Parametric_Ozzy]

But it doesn't work for me!
I created the symbol with inside the note etc.etc. only that displays me exactly asm.mbr.name and not the name relative to the component!

Where am I wrong?

use wf5 (cree elem. pro5)

Thank you.

definitely wrong the syntax, custom symbols must have as a symbol \ .
check well and you will see that it works, read also the guide that explains it exhaustively.
greetings