valori di default

[Ch.giacomo]

Good morning, or a little boring problem with inventor 2019.
I attach photos of how it is before that is default and how I would like it to be later.
practically every time I launch the command I always have to change the values manually.
but I don't understand if you can set default a value I use daily! !
Thank you.

 

[Sleepers]

I don't understand if you can set a default value I use daily! !

I found only this:

https://knowledge.autodesk.com/it/s...ntor-2018-for-extrude-fillet-and-chamfer.html

I understand the problem, it also happens to me to waste time changing the proposed values in different dialog boxes, while I would like to change the default value once and for all.

 

[Ch.giacomo]

I found only this:

https://knowledge.autodesk.com/it/s...ntor-2018-for-extrude-fillet-and-chamfer.html

I understand the problem, it also happens to me to waste time changing the proposed values in different dialog boxes, while I would like to change the default value once and for all.

I gave a reading but unfortunately it does not solve the problem.. I think you can't!!
Thank you.

 

[Sleepers]

since 2003:

Default Chamfer & fillet

Hi all, Is it possible to change the default chamfer and/or fillet values? It currently comes up at 2.0mm. Thank You Mark Smith SPX Air Gage Co.

forums.autodesk.com

Default values for prompted entry text in 'Sketched Symbols' (IDW)

I would like to be able to set a default value for a 'promted entry' when creating a sketched symbol. Just like we can in Autocad blocks. We have some standard weldment symbols with tekst and a border around them. Most of the times these value are standard, but somtimes we need to change some...

forums.autodesk.com

:-(

 

[Ch.giacomo]

since 2003:

Default Chamfer & fillet

Hi all, Is it possible to change the default chamfer and/or fillet values? It currently comes up at 2.0mm. Thank You Mark Smith SPX Air Gage Co.

forums.autodesk.com

Default values for prompted entry text in 'Sketched Symbols' (IDW)

I would like to be able to set a default value for a 'promted entry' when creating a sketched symbol. Just like we can in Autocad blocks. We have some standard weldment symbols with tekst and a border around them. Most of the times these value are standard, but somtimes we need to change some...

forums.autodesk.com

:-(

then my hopes are already over!!! No! .