visualization error

[ilbona]

I use viz 2006 and sometimes in the perspective view the model is only partially displayed, as if there were active two cutting floors that bind me. It forms like a strip where a piece of the model is displayed and a piece of the grid, and you can no longer easily navigate in the view.
Does anyone have any suggestions?

 

[Ilario]

Meanwhile, I see that the perspective view is as default field of view a 45 (set dx on the viewport perspective -> configure in low a dx field of view put 45.0).

then if you still don't need to activate the clipping planes (always dx button on the viewport perspective -> show viewport clipping) you turn on a side yellow bar with two brakes, go on the brakes and drag the top to the top to the top and the bottom to the top to the top.

But I'm telling you that it's a classic problem, you may not be satisfied anyway, but that's the best you can do

 

[ilbona]

First of all, thank you for your concern. I discovered that the problem was created when I eliminated some imported autocad blocks. probably it's a viz mistake that solved in later versions. Now it works great. I will still try to apply your suggestion. Hello