wait lung linea non planare

[Stan9411]

Bye to all,
In essence, I must make a circular section tube (a component of a motorcycle chassis) that winds along a non-planar trajectory. I think you can use the blend sweep command but I don't know how to create a 3d trajectory to give in "input" to the command.
I hope you can help me, thank you.

 

[DANI-3D]

Hi.

I attach an example of how I realize the electrical cables. see if you can use it with the appropriate changes.

 

[Stan9411]

Great! is "curve through points" the command.. I didn't even know it was on ptc. Maybe a bit slender, but judging by the result you got is exactly what I was looking for. I don't know how to thank you! !

 

[DANI-3D]

Great! is "curve through points" the command.. I didn't even know it was on ptc. Maybe a bit slender, but judging by the result you got is exactly what I was looking for. I don't know how to thank you! !

a buon renders :finger:

 

[320i S]

in the swept and sweep variable section, it initially asks if you want to sketch or select the trajectory, with this second setting, you can select more curves (as long as they are tangent among themselves), which gives you infinite possibilities of trajectory in space.
I recommend using the "sweep variable section" command, even for the sections that will remain constant, because there are many extra options for the different cases that can happen, the old simple "sweep" command (active until wildfire 5, then I do not remember if already from creo 1 it has been disabled, is disabled in creo 3), is very limited and will never be converted with the other command.