wall on the mass - voids are not recognized

[kubbah]

Hello I am trying to apply the wall on a mass that was cut out with blanks,
but the wall does not read the carved mass but the original one and therefore the generated form is not the desired one.

Can anyone help me?
Thank you.

 

[Alfredo Medina]

It should work. would be useful if you could see an image.

 

[kubbah]

Here they are.

 

[Alfredo Medina]

I see a relationship between the first and the last image, but not between the third and fourth images, between them or among others.

 

[kubbah]

this image is another case,
the other 3 refer to the same model
Thank you.

 

[Alfredo Medina]

model with solids and empties and very rigid. a shape like that and easier with points, curves and surfaces, and without those problems.

 

[kubbah]

how do I "recalcate" the same geometry
If I have a curved façade in the prospectus and curve in the plant.
if it is a bow, and it is a bow both in plant and in prospect... the points are associated with a "reference plan" (work plane) that cannot be curved of its own.

 

[Alfredo Medina]

the curves sone made with "spline" not with "arc". if you select the curve, you copy it to another floor, or you change the "host" to another level.

 

[kubbah]

splines do not represent 100% the same curve as "arc".
I can't do it with arc, can I?

 

[Alfredo Medina]

That's true. but, unfortunately, an arch" and too "rigid", and the "spline" and very "flexible". a "spline" of 5 points and sewed the same as a bow. Agreed, and not the same, but too close and flexible.