when selecting a retino/treat do not display the vertices (autocad)

[Andre156]

hi, very often when I select a restraint I only visualize the central snap, the ball, but I do not see the vertices that allow to change the restraint. only by moving the retino reappearing the vertices, but it is uncomfortable to do this every time.
Thank you.

 

[MassiVonWeizen]

when you create the restraint, you can pick it up to both associate and annotative.
on already created restraints just open their properties and change the associative voice

 

[Andre156]

when you create the restraint, you can pick it up to both associate and annotative.
on already created restraints just open their properties and change the associative voice

Thank you so much, it was easier than I thought!