create npt holes

[matteoso]

Hello, everyone! I've been eating and taking advantage of greeting you.
I ask the question to fly: is present in proe a library of holes npt, gas, etc.? Of course I know that it is possible to create a hole manually, but it seems strange that there are no holes so used... ciauzzz!

 

[Preparation-H]

Hello, everyone! I've been eating and taking advantage of greeting you.
I ask the question to fly: is present in proe a library of holes npt, gas, etc.? Of course I know that it is possible to create a hole manually, but it seems strange that there are no holes so used... ciauzzz!

http://www.cad3d.it/forum1/showthread.php?t=1476here you find everything you need... :finger:ù

Bye!
p-h

 

[matteoso]

Oh, thank you. :
good thread that reported but I repeat that it really makes me strange that npt holes and gas are not already implemented in proe!

 

[matteoso]

I looked at the files you put and I think it's a good starting point. How come npt holes are not represented conical?e.g. I have to make a npt hole (so conical) from 1-1/2" which goes then to finish with a d=30 passer hole.
if the npt (which has external diam about 48, if I don't remember badly) is not represented conical will not then be connected with the passing hole d30.
Thank you in advance!

 

[Preparation-H]

I looked at the files you put and I think it's a good starting point. How come npt holes are not represented conical?e.g. I have to make a npt hole (so conical) from 1-1/2" which goes then to finish with a d=30 passer hole.
if the npt (which has external diam about 48, if I don't remember badly) is not represented conical will not then be connected with the passing hole d30.
Thank you in advance!

Usually the conical and cylindrical holes are represented in the same way, that is, as if they were all cylindrical.
but if the hole is from 48 how does it not connect with the hole from 30?
Moreover you will still have to drill cylindrical and if the thread is 1" 1/2 the tip that you will use if I don't remember badly will be from diameter 44.. .
http://www.magnabosco.it/mgbt99/htm/parametri/filconicaamericana.htmTry to see if this udf works... I found her on the net long ago. should (I say it should because I never used it!) generate the surface of the conical thread.. .

Hi.
p-h