You know the block at altitude

[Hope]

Good morning.
I press that I am really a beginner in sw.
I needed a special symbol to put on the table and so I made sketches and tied them to a note by making a block.
now I would like to "bind" to a quota the created block.
Can you do that? It would be enough for me to move the quota to move the block accordingly.
Thank you in advance

Say hi! !

 

[MassiVonWeizen]

command "raggruppa"

 

[Hope]

therefore,
I click the quota, click the block (holding ctrl pressed) tools/alignment/group but grouping is gray i.e. not selectable.
I think I'm wrong.

 

[MassiVonWeizen]

therefore,
I click the quota, click the block (holding ctrl pressed) tools/alignment/group but grouping is gray i.e. not selectable.
I think I'm wrong.

probably the note is not linked to the view on which the quota lies.
double click on the view, or select the right view and click "lock the view in the foreground".

 

[Hope]

ahhh are close to exasperation.
I made a mini presentation. Where is it? I just don't understand.
thanks anyway for the answers so far sent me!

Good evening! !

 

[Hope]

ahhh are close to exasperation.
I made a mini presentation. Where is it? I just don't understand.
thanks anyway for the answers so far sent me!

Good evening! !

test and try again I realized that the command group works with annotations but not between blocks and quotas.
Is there anyone who can forget?

 

[re_solidworks]

test and try again I realized that the command group works with annotations but not between blocks and quotas.
Is there anyone who can forget?

I don't know how to do it, I never did it, but couldn't you make a custom solidworks symbol? try to search in the forum of solidworks "simbolo" had spoken a long time ago in a discussion about the two equals under the quota to indicate the symmetry... .