nino66
Guest
Hello, everyone.
I often happen in sw (2010) that start a command, through selection with trap or other commands that the moment after I have executed them I realize that they are impossible, that they would give a mistake or simply puts us too much time and consequently sw begins to think and think.... and, except to kill solidworks himself, there is no way to interrupt without losing everything or wait for it to end up thinking.
the esc key, of course, does not work... .
Is there any way to do this?
thanks and hello
I often happen in sw (2010) that start a command, through selection with trap or other commands that the moment after I have executed them I realize that they are impossible, that they would give a mistake or simply puts us too much time and consequently sw begins to think and think.... and, except to kill solidworks himself, there is no way to interrupt without losing everything or wait for it to end up thinking.
the esc key, of course, does not work... .
Is there any way to do this?
thanks and hello