window to two die united

[larchitettol]

use revit 2013
I joined two parallel walls and put a window on this composite wall.
What happens is that it opens my hole on both walls but it applies the window only on one of the two... Do I have to change the windows family? If yes, an idea about how to do it?
(I also have a small problem about the fact that it does not give me the hole to all the walls united if these are too distant among them.
Thank you!

 

[emi_973]

ciao,

apply the window only on one of the two...

questo mi sembra normale, per come l'ho capita io...

I also have a small problem about the fact that it does not give me the hole to all the walls united if these are too distant among them.

I think it depends on the fact that the vacuum that generates the hole in the host has a limited width and therefore does not intercept the second wall if this is too distant. open the family, widen the vacuum, save and load in the project, overwriting the existing. Better if you save the existing family first, not that something goes wrong.

 

[larchitettol]

open the family, widen the vacuum, save and load in the project, .

How do you enlarge the void?