cocreate 2006 pipes

[tocod2007]

Good morning, everyone.
to create pipes I was suggested to do it with rototranslation, unfortunately I tried but I can not. I have to start a pipe from a fitting on an oleodynamic pump and get it to the distribution block.
Can someone give me a tip on how it is best to do?
Thank you.

 

[cacciatorino]

Good morning, everyone.
to create pipes I was suggested to do it with rototranslation, unfortunately I tried but I can not. I have to start a pipe from a fitting on an oleodynamic pump and get it to the distribution block.
Can someone give me a tip on how it is best to do?
Thank you.

Where are you?

otherwise try this macro:
http://osd.cad.de/lisp_3d_04.htmciao.

 

[tocod2007]

I'm blocking myself from the beginning. I didn't realize if I first had to create a pipe path line or, if everything was done by the program.

 

[tocod2007]

I always used solid edge and this program makes me crazy!

 

[cacciatorino]

I always used solid edge and this program makes me crazy!

You don't know how I understand you.... :frown:

 

[Kaji]

I'm blocking myself from the beginning. I didn't realize if I first had to create a pipe path line or, if everything was done by the program.

It is necessary to create both the section of the tube with a geometry (the white one) in a working plane and then the middle line, which he calls the director.
the director can be composed of geometries within floors, from edges of solids or splines.
to create spline there are also various online tutorials like this
[video=youtube;RGGqlREr4Ro]http://www.youtube.com/watch?v=rggqlrer4ro[/video]