ipart & character "2"

[cen82]

I wanted to know if someone else has my own problem.
1-cree part (s001145)

2-the turn into ipart (s001145-01 , s001145-02, s001145-03, etc... )
3-i identifying characters of the ipart (e.g. 0 1 ) carry them back into a text and follow the escalation to "identify with holes" the sheet

here is the problem
When I generate all iparts, every member where in the name part appears the character "2" gives me a mistake!

At the moment I solve it by never showing character 2, but it seems a bit absurd, doesn't it?
Does anyone else have my own problem or know how to solve it?

Thank you very much

 

[Catafratto]

the generation of the pippo-02 part works me correctly. Maybe the mistake is tied to the "2" bounce?

 

[cen82]

the generation of the pippo-02 part works me correctly. Maybe the mistake is tied to the "2" bounce?

You're right. Does it make you too?

 

[Catafratto]

I tried to bounce a "2" in an ipart and so it works but I set "manually" the value of a text user parameter (I couldn't connect that parameter to the ipart table, what do I miss?). I had a mistake when the text to be stunned was "exploded" on one side, maybe something similar to you too?

 

[cen82]

I tried to bounce a "2" in an ipart and so it works but I set "manually" the value of a text user parameter (I couldn't connect that parameter to the ipart table, what do I miss?). I had a mistake when the text to be stunned was "exploded" on one side, maybe something similar to you too?

I do that.
1-ipart
2- I add columns for character to mark (p01)
3- the name part will be formed by my code (s001144) and column with character. S001144-p01
4- I create the bounce with character (p01)

so when the ipart automatically changes the code written on the piece

 

[Catafratto]

mah, I can't connect the ipart column with the escalation sketch, in the morning with the fresh I try again that today are well cooked. Anyway trying in "semiautomatic" errors doesn't give me any...