postprocessor per topsolid

[Mcgyver]

Hello everyone, I would need a topsolid postprocessor, which creates a standard iso encoding and siemens 840d.
Can you recommend something? ? ?

Thank you all in advance! !

 

[Shrek]

What version? 6 or 7?

 

[Mcgyver]

Topsolid 7, grazi shrek!!

 

[Mcgyver]

Is there any way we can do the post processor? ?
I read on the internet that for other programs like mastercam etc. it is possible! !

 

[Shrek]

I'm sorry, but I stayed at v.6, but you're sure you've installed the whole package, there should be a set of generic posts you can configure.
Having a post-processor is not a joke, you must have c++ programming bases, in fact if they make them pay very well, then at the limit the user can configure it better to adapt it to the various versions of the cnc but not more.

 

[Mcgyver]

I'm sorry, but I stayed at v.6, but you're sure you've installed the whole package, there should be a set of generic posts you can configure.
Having a post-processor is not a joke, you must have c++ programming bases, in fact if they make them pay very well, then at the limit the user can configure it better to adapt it to the various versions of the cnc but not more.

Save shrek, would you tell me in topsolid 6 how and where the post is configured? Thank you! !

 

[Shrek]

Sorry, but in v6 there isn't, you have to have the extra package to install, which you can still find on the various "official" servers as a version of "proof".

 

[Mcgyver]

Sorry, but in v6 there isn't, you have to have the extra package to install, which you can still find on the various "official" servers as a version of "proof".

Sorry for the delay, but thank you for the answer!:smile: