secrets of flea: drawing board sheet metal wf4

[mackly46]

Guys, you can tell me how to set table 2d for a sheet metal model.
Is it possible that I don't find a sheet where I write 2 rows how to make a table from the sheet model all over the web and you tube? ?
Is there the secret of flea behind such a design? ?

Bah. .

 

[DANI-3D]

Hi.
There is no secret, it is all in the light of the sun. just read any guide online.
you have to create the flat state, call it back in the drw and quote it.

 

[mackly46]

thank you so much dani, I finally found how to make the flat state of the sheet.

 

[DANI-3D]

Thank you very much...

... please... if you need, whistle.
greetings

 

[mackly46]

thank you so much you are too kind dani, I stand moving the first steps on this field of the plates! I'll show you that it's not easy here.
you went to 3?? or are you still at the wf5? ?
You know what evolutions are worth at this point?
I had a student license from the wf4, but now they make me go to the creo, I couldn't with that formula study on it.
Do you have advice?

 

[DANI-3D]

Hi.
I still have wf5, I just gave a peek at creo 2 and I can't tell you the differences, however if you are looking in the forum you will surely find information, because this topic has been treated.