linking design properties with the journal.doc clipboard model ""

[lucadileta]

Hello everyone, I wanted to ask if anyone had any idea of how to connect the information contained in the folder of a part drawing or together within the journal.doc document. the problem exists because some information contained in the cartiglio is not defined in the properties of the model but is read by the model that is inserted in the table itself.

thanks to all in advance

♪

 

[meccanicamg]

less bad that it is so otherwise nothing would work.
What's your real problem? if the properties are written in the part of the plate it is normal that the board associated with the amounts when entering the model in the table. There's something abnormal about what you describe. explain yourself in detail.

 

[lucadileta]

I think I explained badly then. Consider that I have a project newspaper where I want certain information that is governed by a property that does not exist in the property manager of my table. obviously in the table inserting a part or a set he loads this property in the sheet. Here comes the beauty. If I want to automatically write that information in the project newspaper I can't do it, or at least until now I couldn't. for example writing prpsheet:"sw-mass" he in the project newspaper nn reads nothing. I hope you understand a little more.

 

[MassiVonWeizen]

and the information contained in a drawing of part or together within the journal.doc document. the problem exists because some information contained in the cartiglio is not defined in the properties of the model but is read by the model that is inserted in the table itself.

What you wrote doesn't make sense. You're making a denial of a statement. if not defined in the model as you read them in the model'
not with the loopholes, the cartiglio reads the properties that you have inserted and that are contained in the model

for example writing prpsheet:"sw-mass" he in the project newspaper nn reads nothing

prpsheet:"sw-mass" is a design environment variable; all variables that contain sheet are of design environment. so if you insert them in any point (journal, annotations, property...) of environment part or together will not read you anything
I was going to read this page http://help.solidworks.com/2016/italian/solidworks/sldworks/c_design_journal.htm

 

[MassiVonWeizen]

see also this discussionhttps://forum.solidworks.com/thread/4550

 

[lucadileta]

see also this discussionhttps://forum.solidworks.com/thread/4550

Hello Masses, native thanks to the infromations. Now I try to explain in the simplest way possible with an example because it is all more trivial than it seems:

I have my journal.docx file with certain fields that you have to autocompile. this word must go well for all environments or: part, together and drawing. of course the properties I have defined are not the same in every environment. Now my practical problem is, for example, the following:

I am in drawing environment and I want the information of the mass of the part or the axieme that is located in the table to complete the appropriate field in the word file. being the mass property not a property of the drawing but only of the part or together is there any way to read it and write it automatically on the word file?

I hope I've been a little clearer:/