align quota to a board

[MARCOC]

Good morning to all, I ask you a question similar to a discussion made in the past for the alignments of the axes, I must align a quota to a board, is this possible in solid?? ? ?

image place for clarity
thanks to all

 

[MassiVonWeizen]

https://www.cad3d.it/forum1/threads/esecuzione-quotatura-inclinata.52850/#post-413928

 

[MARCOC]

Massive, I select the diameter portion, but then there's no line on the edge, then the option is there alone if you put the quota by selecting 2 points
Can you align a diameter portion? ? ?

 

[MassiVonWeizen]

with grip above the altitude

 

[MARCOC]

which massive grip?????????, can't post an image please

 

[MassiVonWeizen]

the one above 21

 

[MARCOC]

ok mad you hose the circular arrow, but that rotates the quota to established degrees, you can not align it to a edge at your scelts

 

[MassiVonWeizen]

It's the only mine.
give us an answer about how you solved the perpendicular circle?

 

[MARCOC]

so there is no automatic solution, it does nothing
instead of your question, are you talking about circle? ? ?

 

[MARCOC]

this discussion was for the positioning of the hole quotas,the others can align all

 

[MassiVonWeizen]

instead of your question, are you talking about circle? ? ?

memoria cuts eh...https://www.cad3d.it/forum1/threads/cerchio-perperdicolare-a-curva-3d.54255/page-2#post-422777but I'll take you back to some other people you haven't answered:https://www.cad3d.it/forum1/threads/aggiungere-dimensione-a-elementi-strutturali.54044/https://www.cad3d.it/forum1/threads/curva-da-equazione.54015/#post-421261

 

[reggio]

the one above 21

the devil of a massivonweizen ... the sà proprio all ... eh eh...

Good to know

 

[MassiVonWeizen]

you can also set the snap for rotation of quotas, but not in linear modality, setting the voice radial/diametral association line snap angle in http://help.solidworks.com/2018/italian/solidworks/sldworks/hidd_options_dims_new.htm