problem display envelope table

[lucadileta]

hello to all, making a table of a set with sw16 of which some parts and subassiami are envelopes does not show the lines of the aforementioned as dotted but well-maintained full stretch. is normal as what?

greetings and thanks in advance
♪

sent by my sm-n950f using tapatalk

 

[MassiVonWeizen]

bored problem already discussed in the forum. as the guide says otherwise there is no way to see the lines
but for your version should have been solvedhttps://forum.solidworks.com/thread/76343

 

[lucadileta]

bored problem already discussed in the forum. as the guide says otherwise there is no way to see the lines
but for your version should have been solvedhttps://forum.solidworks.com/thread/76343

Thanks massive, apparently so in the sw16sp5 version I have to keep them like this.