overlapping yellow and red mesh for comparison table

[Francesco Bianchi]

Hello, everyone. Can someone tell me how to do or do I have to find a retino for the overlapping red and yellow? I'll explain. I have to indicate a demolition and a reconstruction of fact coincidence because the reconstruction is identical to the demolition, so I thought to make for the comparative table a net with diagonal bands, a yellow and a red in sequence. If I do it by hand, drawing the lines at 45° and retinando I put a week.

Can you help me? use autocad lt 201.

Thank you.

 

[MassiVonWeizen]

make a snail nethttps://knowledge.autodesk.com/it/s...264748ae-55fb-453a-8366-db4c3a3d4723-htm.html

 

[thelittlesniper]

you can also make a full retino and one at a time (type ansi31) or you can make both retini ansi31 but one by a 90° wine.
The nugget could deceive. . .

 

[Francesco Bianchi]

the effect I want to get is that in the attached file. to do that thelittlesniper I should explode the retini ansi31 and then apply the two retini full one yellow and one red... I don't know. keep in mind that I have no clean boxes but that intersect a quantity of lines.

 

[thelittlesniper]

the effect I want to get is that in the attached file. to do that thelittlesniper I should explode the retini ansi31 and then apply the two retini full one yellow and one red... I don't know. keep in mind that I have no clean boxes but that intersect a quantity of lines.

to get something similar to the annex you can make a "solid" yellow and above there positions a "plast" red and perhaps to the latter from also an important line thickness so you have the red that will seem a second fill (see photo attached).

 

[MassiVonWeizen]

with the litylesniper solution you can create a pattern that repeats the lines for a dozen times (for example) with a minimum distance and then has an equally wide blank space.
look at the other restraints (plastic or some anxiety) you find one he has the pattern with repetitions with non-consistent step, copy it and change it by doing some tests

 

[Francesco Bianchi]

Thank you all. I try. I imagine that creating the custom retino as an automatic function is not so easy.

 

[MassiVonWeizen]

open the acad.pat file, open it with note block, look for ansi134 or what you have judged similar in the retini, cover the rows concerned at the bottom of the sheet and add them going to attempts. on the network you will certainly find an explanation of values by editing autocad restraints

 

[Francesco Bianchi]

Thank you

 

[Francesco Bianchi]

you can set up. also the background color of the plastic. That's how it comes. I have to see how to print the edges though.

 

[x11start]

You could also make a block with 2 colors and then use the superhatch command of express tools to fill the affected area.

 

[Francesco Bianchi]

You could also make a block with 2 colors and then use the superhatch command of express tools to fill the affected area.

You could also make a block with 2 colors and then use the superhatch command of express tools to fill the affected area.

Thank you. You too. I solved with plastic nets and ansi31

 

[Francesco Bianchi]

You could also make a block with 2 colors and then use the superhatch command of express tools to fill the affected area.

Retina layer... .