← anomala your tavola

[deep70]

Hello everyone,
I would like to point out that I am not very experienced with inventor, and that I consider it an excellent modeler, so I find myself struggling with the following problem:
At the table of the first sight of a general assembly, the same represents only a part of the axieme, that is, sub-axiemi are not represented completely and in a dotted form as if they were in a certain sense hidden or however hidden.
You know how to tell me how to solve this? place a couple of pictures that make the idea of the problem better.
Thank you all in advance for any dates, good evening to all.

 

[Cast16]

Are the components "referenced" in bom of the assembly?

 

[deep70]

hello cast16, thanks for the answer, I checked but it's not that unfortunately.

 

[Catafratto]

from the description of the problem I would say that cast16 gave you the right tip, also try to verify from the distinct components the incriminated pieces, could be nested. . .if you do not see the column:

 

[deep70]

I repeat, and I apologize to both of you, the problem was precisely that, now thanks to you solved, thank you very much cast16 and catafract.