20° order

[Geppetto82]

Bye to all,
how is a 20° bevel made as an attached design with a vertical working center with control fanuc 16i-mb?
Is there a fixed cycle?
thanks to those who can help us.
greetings
geppetto82

 

[andrea_sec]

hi! even if it has passed about a month and I think you will have done, there is no fixed cycle.per fixed cycle you mean centring(g81) drilling(g73/g83), threading(g84) and baring(g85)(I hope I haven't skipped anything). In this case the solution that I see can go well is to calculate the point after the connection radius and then the final point.

 

[Mike1967]

hi! even if it has passed about a month and I think you will have done, there is no fixed cycle.per fixed cycle you mean centring(g81) drilling(g73/g83), threading(g84) and baring(g85)(I hope I haven't skipped anything). In this case the solution that I see can go well is to calculate the point after the connection radius and then the final point.

Yes, a year and a month.

 

[Geppetto82]

Good morning!
if I remember correctly the piece was executed at the lathe. for the work centers we have carried out the course on mastercam and there is the function on purpose. I wouldn't have a problem with relishing it today. Thanks anyway!