p3ppi
Guest
Good morning to all,
looking at the inventor guide and in the tutorials I can not understand well when you need to use a 2d contact in the joints and when using a 3d contact.
Looking at the preview in the joint window I do not understand in which case it is more appropriate instead of the other.
Can anyone explain it to me?
Thank you!
looking at the inventor guide and in the tutorials I can not understand well when you need to use a 2d contact in the joints and when using a 3d contact.
Looking at the preview in the joint window I do not understand in which case it is more appropriate instead of the other.
Can anyone explain it to me?
Thank you!