3d model export in dwg format with layer

[Shotfree]

Good afternoon to all,
I would need to export a 3d set containing solids and surfaces in dwg format. here no problem, select the export and end fromate, the problem arises when in autocad/nanocad it is, I try to select the entities, since these are exported as broken and discontinuous mesh. in this regard I would like to place on different layers the different entities (boom parts), but also assigning different colors I do not get advantages.
Would someone help me?
Thank you.

 

[Shotfree]

Good morning to all boys, only by curiosity, my question has no solution or the portal is "dead"? I see very little reactivity.
thanks for the answers.

 

[x11start]

probably the failure to answer is due to the fact that you have wrong section: you put the question on the section I create parametric, instead of autocad.

 

[Shotfree]

probably the failure to answer is due to the fact that you have wrong section: you put the question on the section I create parametric, instead of autocad.

ciao @x11start , the section is correct, because it is from creo that I would like to get an export on layer, then perhaps I did not express correctly in asking the question. basically I would like to export a 3d made of creo, but get a level for each component (which I know based on the color of the component or the like, a little as it happens for the objs).
Thank you for the answer!

 

[MassiVonWeizen]

Good morning to all boys, only by curiosity, my question has no solution or the portal is "dead"? I see very little reactivity.
thanks for the answers.

where do you see very little reactivity if there are new discussions every day and dozens of answers?
if it seems to be unreactive you can help by making your contribution

 

[Shotfree]

where do you see very little reactivity if there are new discussions every day and dozens of answers?
if it seems to be unreactive you can help by making your contribution

ciao @massivonweizen I always do if I have answers to give, it simply seemed strange not to receive even an answer about the topic (usually at least one or two have always been in the past). Meanwhile I thank you for confirming the activity of the door! for me is a reference.

 

[mamobono]

I have not created but wf4 but see here

https://support.ptc.com/help/creo/c..._exporting_drawings_to_dxf_or_dwg_files.html#

read is explained well

you need to create a mapping file where to say how you want export to happen, set the config and then maybe a macro associated with a function key that saves the result in a folder so as to speed up the process

Hi.

 

[Shotfree]

I have not created but wf4 but see here

https://support.ptc.com/help/creo/c..._exporting_drawings_to_dxf_or_dwg_files.html#

read is explained well

you need to create a mapping file where to say how you want export to happen, set the config and then maybe a macro associated with a function key that saves the result in a folder so as to speed up the process

Hi.

I see right away, thank you.