a couple of questions about creo parametric

[maxopus]

I'm putting my hands in depth on "creature."
no problem about modeling, assembly ... I have to get used to the new interface for drawing but, even here I have not met problems worthy of note.

But a couple of things don't come back and I wanted to know if any of you went into the same problem.

I press that I am using the build m010 64 bit on seven pro 64 but, the same problem I have on xp 64.

1) Where is the bin/text/fonts folder for the use of fonts not included in the installation?

2) How does the license loan (borrow license) work me by launching the ptcborrow file? the procedure seems to go well but, if I turn off the license server... the license no longer acts.

for the moment it is all... hasta the view.

 

[folle76]

1) I put in c:\program files\ptc\creo 1.0\common files\m020\text\fonts the fonts I use for text in sketches (e.g. arial). I don't know if the route is your case.
2) I had problems with the license manager (most trivial case: machine on which I turn creo that also makes from license servers) and the assistance advised me to do the downgrade (ironic word) to the old wf5 license manager

 

[re_solidworks]

1) I put in c:\program files\ptc\creo 1.0\common files\m020\text\fonts the fonts I use for text in sketches (e.g. arial). I don't know if the route is your case.
2) I had problems with the license manager (most trivial case: machine on which I turn creo that also makes from license servers) and the assistance advised me to do the downgrade (ironic word) to the old wf5 license manager

i.e. you say you use the wf 5.0 license manager with creo 1.0?

 

[maxopus]

on this I do not see any drama is a problem often related to compatibility with I know.
on our server is installed the license server of the wf3 and works with all subsequent releases.