abbaino problem

[jamba_ITA]

Hello everyone,
as you will understand I am a novice of revit. Now I have a problem with the barks. I realize the tie in the correspondance of the windows "cut" the cover and above I realize another (which then would be the real bark). if for the outside wall not so far are problems are not like to realize the two walls that delimite to dx and sx the abbey itself. I can associate them on the sash of the barn but not on the general cover. I don't know what plan I have to make them even because in the plant I shouldn't see them.. . .

 

[Tristan]

the association is made both at the top and at the base; look in the revit options bar when you launch the command "associa parte superiore/base"

 

[jamba_ITA]

I saw him, too, and I thought it was easy.
I design the brick walls on the floor where I see the cover. from view 3d selection the wall and click on associate... and selection the main cover but get as answer:
"The union of the wall highlighted with the highlighted element moves the upper part of the wall under the lower one or the lower part above the upper one or interferes with the joints or holes of the wall. "
but if I design the walls on the floor under the cover I associate only the upper part.

 

[Tristan]

you set "base" in the command options, how did I write you in the previous message??

 

[jamba_ITA]

I had it under my eyes and I didn't see that option:redface:

 

[jamba_ITA]

Now I don't miss that I understand how to change the various families (I must be able to make windows and doors as you must) and find the way to have a detail of the analytical volumes.