Amfa4855
Guest
Hello, everyone.
I recently passed to the inventor's 2010 release to enjoy the new features and features for the management and creation of injected plastic products.
Everything went well until I found myself having to create the "reinforcing rib" that characterizes the outside of the shells and that serves precisely to strengthen the surfaces of the plastic and thus avoid any deformations.
I know that the function, at least in that case, was there.
in inventor there is nothing like this? I tried to play with the "grille" function but it is not conceived for this type of function.
Of course, on Monday, I will test the service:wink:, but if anyone knew anything about it... Come on! !
:smile:
I recently passed to the inventor's 2010 release to enjoy the new features and features for the management and creation of injected plastic products.
Everything went well until I found myself having to create the "reinforcing rib" that characterizes the outside of the shells and that serves precisely to strengthen the surfaces of the plastic and thus avoid any deformations.
I know that the function, at least in that case, was there.
in inventor there is nothing like this? I tried to play with the "grille" function but it is not conceived for this type of function.
Of course, on Monday, I will test the service:wink:, but if anyone knew anything about it... Come on! !
:smile: