Rix
Guest
Hello everyone,
I present myself in this forum, I am rich and I am struggling with the ing.meccanica thesis and the "benedetto" adams!!
putroppo the poor experience in such software, and the practically inexistence of guides or tutorials is sending me a little in crisis!
I am modeling a suspension, and so far no problem...the problem arises in the creation of the road surface on which to move my wheel- suspension group.
banally it will have to be a kitchenette and a dosso, to observe the various excursions, which I basically managed to create, but now I would like to add "irregularities" to my path and here I am going crazy! I would like to create a sloped downward plane compared to the axles.
to create the path, after fixing my points and joining them with a polylinea I applied the extrusion to the plan so created. Such extrusion is applicable, until the extrusion plane is parallel and normal to the axes, if that plane is tilted everything does not work.
Unfortunately I realize that explaining in words is complicated, so I simplify everything by asking you some general tip on how to create solids with sloping and irregular surfaces.
Thank you in advance, I greet you...for now!
I present myself in this forum, I am rich and I am struggling with the ing.meccanica thesis and the "benedetto" adams!!
putroppo the poor experience in such software, and the practically inexistence of guides or tutorials is sending me a little in crisis!
I am modeling a suspension, and so far no problem...the problem arises in the creation of the road surface on which to move my wheel- suspension group.
banally it will have to be a kitchenette and a dosso, to observe the various excursions, which I basically managed to create, but now I would like to add "irregularities" to my path and here I am going crazy! I would like to create a sloped downward plane compared to the axles.
to create the path, after fixing my points and joining them with a polylinea I applied the extrusion to the plan so created. Such extrusion is applicable, until the extrusion plane is parallel and normal to the axes, if that plane is tilted everything does not work.
Unfortunately I realize that explaining in words is complicated, so I simplify everything by asking you some general tip on how to create solids with sloping and irregular surfaces.
Thank you in advance, I greet you...for now!