add profile size to the frame generator library

[windreef]

Good evening,
I wanted to know if it was possible to add size to the normalized profile library to create frames with frame generator. I do not need to add a new profile, but to extend the measures available in the chosen norm that are strangely lower than those available in the legislation, and I do not understand why.
an example to make me understand better:
standard un en 10219 profiles 60mm start from a height of 40mm when in reality there are also of 30mm for example, and so many others are not present even half the measures available
Thank you.
Hi.

 

[windreef]

the only solution I found is to copy the original family of the contained center and in the copied (modified) add the missing size. I don't know if there are other solutions but this works and all in all is also fast.