aggiornamento quote

[Bidaniele]

Good morning
use inventor 2014 and I noticed that it has a problem in the upgrade quotas.
I make the table of a particular and quoting the circular axis of 3 or more holes.
open the particular and change the size between the axis and the hole
the quota in the table is not updated and is not even highlighted!!!!! !

Does it happen to you? ? ?

Hi.
Daniele

 

[bradipo666]

do you have "postic updates" activated?

 

[Bidaniele]

no I found where to select " postpone updates "
but I noticed something:
If the value of the holes is given, the quota shall be updated if the circular axis is not updated.
is it normal or isn't it? ?

Thank you very much for your help

Daniele

 

[PaoloR1]

mmm, let me understand. you have a hole, then a set of holes that have the center on the "main" hole; type a flange, with a set of threaded holes x mount it. you select the center of the hole and the threaded holes through the command "centered series", after quoting. if then on the 3d change the diameter of the series of holes, automatically updates the quota of the table.