aid for table

[Paolinho]

Hello, everyone.
opening the file that I attached to you, I ask you to help me understand what is the best way to put this sheet metal distributor on the table.
Consider that the pieces are three, namely the two vertical walls and the welded cover along these walls. apart from the lid, I thought to put on the table a development of these two side plates, but how do you develop? ... Of course I have attached you a quick sketch of what will be the piece, so the three parts are not separated, but at this stage I would like to know whether to put on the table as I said is the best method or there are other ways to put on the table a similar set.
Thank you all.

 

[diegus]

Well I would say that the best way is to make a board with the maximum odds and positioning of the individual parts. then make a table with the measurements of all the plates that make up the axieme (developed and not).

 

[Paolinho]

Okay diegus, thank you for the answer.
In fact I did so, I inserted a view of the complete assembling of the references of the parts and drew a development of the two vertical walls. all this however for a previous case, simpler.
If I wanted to develop those two vertical walls, and then obtain the parallelogram of the sheet, is there a way?
Hello, thank you again.