rallye
Guest
hello to everyone, I have a problem during the table of a flange.
I have done a section of offset and in the side view (projection of the view in the plant) when I try to quote the diameter on which the holes d.12 lie (d.216 circled in red) I place the quota in a "errata" way. It's kind of like he didn't see the section aligned.
Is there a parameter or a way that allows me to solve the inconvenience?
Thank you!
I have done a section of offset and in the side view (projection of the view in the plant) when I try to quote the diameter on which the holes d.12 lie (d.216 circled in red) I place the quota in a "errata" way. It's kind of like he didn't see the section aligned.
Is there a parameter or a way that allows me to solve the inconvenience?
Thank you!
