SE-Bologna
Guest
Hello, everyone.
during the arrangement of the coordinate quotas, these are aligned automatically at zero.
to dispose at will, I must then use "interrupt group of alignments" or drag the stake of the quota with the high pressed.
the "automatic alignment quotas" icon is disabled.
all quite uncomfortable if the odds are many.
I'm sure that many years ago (it's a little I don't use if) I had one at one already in the desired location, when selecting the edge (or point or circle) to be listed.
What is the option?
Thank you.
during the arrangement of the coordinate quotas, these are aligned automatically at zero.
to dispose at will, I must then use "interrupt group of alignments" or drag the stake of the quota with the high pressed.
the "automatic alignment quotas" icon is disabled.
all quite uncomfortable if the odds are many.
I'm sure that many years ago (it's a little I don't use if) I had one at one already in the desired location, when selecting the edge (or point or circle) to be listed.
What is the option?
Thank you.