aluminium container design hammond

[cirillo87]

Hello everyone,I have to design an aluminum container of the hammond series 1590,ip54,screened,black,187.5*119.5*78mm on nsolidworks 2017.adesso I send you photos with the datasheet!

 

[New Rider]

Hello everyone,I have to design an aluminum container of the hammond series 1590,ip54,screened,black,187.5*119.5*78mm on nsolidworks 2017.adesso I send you photos with the datasheet!View attachment 50232View attachment 50233

So?

 

[MassiVonWeizen]

Are you commissioning a job?

 

[cirillo87]

So?

when I make the container,excluding the lid,I have a gap between the top part and the bottom part of 3mm because above the container is 188*120mm and below is 182*114mm,how do you do the flushing?

 

[cirillo87]

Are you commissioning a job?

Yes, it is the work of my thesis!

 

[New Rider]

when I make the container,excluding the lid,I have a gap between the top part and the bottom part of 3mm because above the container is 188*120mm and below is 182*114mm,how do you do the flushing?

I think it's the extraction sform. . I think. .
and do not flood the forum with the same message in the various sections. . .

 

[MassiVonWeizen]

Then why should someone else do it?

 

[cirillo87]

I think it's the extraction sform. . I think. .
and do not flood the forum with the same message in the various sections. . .

So when I go into the deformed function... there should be disformed by extraction, imagine!

 

[MassiVonWeizen]

but do you know how to use the program or are you randomly pulling hopes for some way to catch us?

 

[MassiVonWeizen]

instead of describing, word I use with wide margin, your problem, attach the file that anyone can try to understand what you have done there what needs to be settled.

 

[meccanicamg]

Why don't you do the tutorials and then try again?