dreampippi
Guest
Bye to all,
I have to draw a hub of a roller, tilted with an espresso angle in grades-first-seconds. this lets me do it by typing right at the time of the creation of the angle in the sketch (e.g., 3rd 12' 23") even if automatically converts it to normal degree angle. in the table, however, comes out the angle expressed in degrees, the classic corner we say. the customer wants the angle expressed as written above. Is there a way to make it appear at the table? of course without forceing the text quota! Thank you!
I have to draw a hub of a roller, tilted with an espresso angle in grades-first-seconds. this lets me do it by typing right at the time of the creation of the angle in the sketch (e.g., 3rd 12' 23") even if automatically converts it to normal degree angle. in the table, however, comes out the angle expressed in degrees, the classic corner we say. the customer wants the angle expressed as written above. Is there a way to make it appear at the table? of course without forceing the text quota! Thank you!
