ansys - nonlinear analysis and material modeling

[piersilvio]

Hi, I have a doubt about using ansys 12 wb. I should practically model a particular non-linear material and should perform a non-linear analysis. when choosing in analysis system the static structural, in the part of engeeneering date does not allow me to model a non-linear type material. how do you upload generic load data? Thank you all.

 

[bio]

Hi, I have a doubt about using ansys 12 wb. I should practically model a particular non-linear material and should perform a non-linear analysis. when choosing in analysis system the static structural, in the part of engeeneering date does not allow me to model a non-linear type material. how do you upload generic load data? Thank you all.

open the data engineering, enable the library building (1), add a material (2) and drag (3) the data you want to insert on (4)... then click on + (5) and in simulation you will find the material you created. .


bio

 

[cacciatorino]

Hi, I have a doubt about using ansys 12 wb. I should practically model a particular non-linear material and should perform a non-linear analysis.

Do you have a licence for linear analysis? I'm asking you because it's extremely expensive and so often the ansys you see around are just linear.

 

[cacciatorino]

Do you have a licence for linear analysis?

Of course I meant non-linear.... :frown: