approximate quotas (inventor 2011)

[Catafratto]

I would like to have the possibility, as in autocad, to set for quotas an approximation of 5 in 5 or 10 in 10 in the table; I often realize the elements whose size is not a "round count", like the height of a roller coaster recordable on feet, and it bothers me to see odds like "848" instead of "850", but to change the asses for this would be just lost time. Maybe there's an option somewhere I don't see?

Hello everyone and thank you!

 

[Tarkus]

I would like to have the possibility, as in autocad, to set for quotas an approximation of 5 in 5 or 10 in 10 in the table; I often realize the elements whose size is not a "round count", like the height of a roller coaster recordable on feet, and it bothers me to see odds like "848" instead of "850", but to change the asses for this would be just lost time. Maybe there's an option somewhere I don't see?

Hello everyone and thank you!

What? !
I also asked for lumens in the past, but there is no rounding quotas in inventor, as you said, in autocad yes...

 

[geom.Benassi]

practically in the table, after putting the quota, you appear the tolerances and the primary units, above these there is the possibility to change the quota

 

[Catafratto]

Yes, but the static modification: I would like the quota to be updated dynamically, following the geometry of the model, with the desired rounding. . .