jack.84
Guest
good day to all, I am francesco and use pro-e wildfire 3. I tried to find arguments on this matter but I couldn't find anything about my problem.
in the table, when I visualize the section plans and the relative arrows, I often happen that the arrows, instead of pointing on the line stretch point, as it should be, starts from it with the arrow pointing on the opposite side. I tried to reverse the removal side of the material but only changes the direction of the arrow.
based on my knowledge I know that the tip of the arrow should point on the line of the section plan and not start from it. Also on the norm uni 3971 relative to the sections I could not find anything.
Now I would like to know whether a table that looks like the attached image is correct or not.
thank you in advance to those who will give me clarification on this.
in the table, when I visualize the section plans and the relative arrows, I often happen that the arrows, instead of pointing on the line stretch point, as it should be, starts from it with the arrow pointing on the opposite side. I tried to reverse the removal side of the material but only changes the direction of the arrow.
based on my knowledge I know that the tip of the arrow should point on the line of the section plan and not start from it. Also on the norm uni 3971 relative to the sections I could not find anything.
Now I would like to know whether a table that looks like the attached image is correct or not.
thank you in advance to those who will give me clarification on this.
