attachments in simulation

[Daniel San]

hello to all.:smile:
I tried to find an existing 3D on my problem but I found nothing satisfactory. :frown:

In practice I have to run a ball bearing on a folded plate, and I am bearing must follow the piego. by autlizzando the allega fiction, the ciscinetto follows only that flooded surface, and not the profile of the dish.
place an image, which I think is better than 1000 words.:biggrin:
I tried to form a unique surface but nothing to do.
Do I have to use the sweep to make the bearing the trajectory I want (as well as follow the fold of the plate on which it flows) or is there a shortcut?
All I need to do is video.
Thank you in advance!

 

[re_solidworks]

try so, it works to me:

change the bent sketch. side selections, fitting and side and click tools->spline tools optimized, then extrude the spline that generates you swx.
extrusion is very similar to the original but it turns out to be a unique face.
at this point from a tangency between the bearing and the surface and the game is made.
Try and tell me if you don't understand.

 

[Daniel San]

Everything works!
Thank you very much.:smile: