autocad civil 3d: problem with country kit for editing until

[michele1986]

Hello, I installed on autocad civil 3d the "country kit" for editing until Italian. I have the problem I don't see in the toolspace, you know how to help me?

I know it's not the dedicated page but I didn't know where to write

 

[Tristan]

version of civil3d? What do you expect to find in the toolspace that I did not understand? until?

 

[numero1]

if I remember them well until they indicate (in the plant) the change of slope of a road in detected, the slopes for example.
but it's been so long...

 

[Tristan]

if I remember them well until they indicate (in the plant) the change of slope of a road in detected, the slopes for example.
but it's been so long...

what sono the beard

 

[numero1]

what sono the beard

right! :
remains the mystery.

 

[frasco]

http://www.treccani.it/vocabolario/fincatura/in the layout on a large sheet of a design/design, in order to fascicular (and not only) the same in the standard size, it is of common use to indicate with small strokes - until - the bending lines.

I can't believe

 

[numero1]

aaahhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh clarified the mystery.
I don't know if and how these are available in civilization, but once the bending lines were not directly in the sheet's square?
So it would be enough to choose a European format, would it not?
What did I miss?
Where am I wrong?
:

 

[Tristan]

http://www.treccani.it/vocabolario/fincatura/

Forget it. ..what mentions the vocabulary has nothing to do with until quoted by michele1986
le as long as in civil3d are the upper/lower elements of a profile view or view section showing salient data of the elaborate (e.g. partial and progressive distances, earthly quotas, project quotas, patterning etc...)

 

[frasco]

I have actually neglected the scope of the request.

I can't believe

 

[michele1986]

Civil 3d 2015... in the country kit there is a series of until called "executive_ck2015" when I go to click on profile-new series view until, among those available is not present executive_ck2015. is not even present in the instrument area.

 

[Tristan]

sure you used the right template?

 

[michele1986]

sure you used the right template?

What is the template?

I simply downloaded the Italian country kit and followed the installation procedures, I noticed that I have 2 icons to start civil 3d called :
-civil3d 2015 italia
-civil3d italian metric

I see the elements of the Italian country kit.

 

[michele1986]

correction

I just opened civil 3d 2015 and found the country kit installed

 

[michele1986]

Hello.
I wanted to know if in civil3d it is possible to create dynamic 3d solids, i.e. that when I create them in the planimetry I would like to see them both in the profile view and in the sections and that modifying the 3d object created in the planimetry is changed both in the profile and in the sections automatically.

(I write here because I can't create a new discussion)

 

[Tristan]

https://knowledge.autodesk.com/supp...2443a19b-0191-41b0-9505-91f2eb437c59-htm.html