automatic deactivation/activation of relationships? ! !

[uforiky]

Good morning to all,
question of the day (I looked on the forum but I find nothing about it. . . ):

I have a "x" set where inside I have a "a" plate and its bolting that fixes it.
Now I want to "try" a different plate "b" and I would like to create two configurations for this "x" assembly where I can quickly activate/disactivate the two configurations (discussed but come from solidworks and are called so) but above all (and here is the problem that I can't solve) that the various screws/washers stand automatically according to the plate (but this speech can apply for any component, not only bolt).

I tried to create two "Detail Levels" where I go to suppress the plate that I don't care, but the respective relationships with the bolts remain active (I tried to disable them when they are in the other level of detail, but then they remain deactivated even in the level of detail where they need me). is there no system for which relationships automatically activate/disable based on the configuration I have activated?

I was told I have to do it manually. . I hope that's not true, it would be absurd. .

I hope I explained.
Thank you.

 

[Matteo Cappelli dis.CAD]

the command is representation positions
http://help.autodesk.com/view/invntor/2014/ita/?ghttps://www.youtube.com/watch?v=krtul3_0szwuid=guid-c728dfac-1b45-4879-a004-45a8dc991954

 

[uforiky]

mmmmm no...in representations/positions if we weigh a component, then the latter also gets suppressed in all other positions...and that doesn't suit me...

the video you linked me just shows how to use the placements but at equal component. here instead I want to replace a plate with another and have the bolt that according to the selected configuration it mates correctly.

It's something solidw did in two seconds, I can't find the command or solution here. . .

 

[Matteo Cappelli dis.CAD]

Hi.
then usually together with the representation of positions, with the same name, I manage the representation of views
(on/off)

 

[uforiky]

Do you do everything manually? and if you have 10-20-100 components?

I don't want to believe it. . .

 

[Matteo Cappelli dis.CAD]

In that case I make an ilogic...
but you know, following the management, I divide the groups between them and therefore, ass in "multiconfiguration" I have few... just to do feasibility studies.... and the "variable" components are less than 10