automatic properties in table - solidworks 2011

[FIGOR71]

Hello, everyone. .
how can I put the properties into the table automatically. . .
I'll explain better.
1)- bubble - img. pos.1
if I insert in the bubble number part gives me a number... What is it?

2)- number of pieces -
Is there any way to get it inserted automatically? Where do you get the number of parts inserted in a set?

3)- weight tot.-
how can I make him calculate this value based on the mass property already inserted automatically?

I'm sure someone will give me the right answers!

thanks and good work

 

[michele81]

Hello, everyone. .
1)- bubble - img. pos.1

2)- number of pieces -

3)- weight tot.-

creating a table connected to the axieme does all this automatically and in a very simple way
pass from the properties of the single part is possible only if you impose the number of parts present; then through equations you can get the total weight.

 

[re_solidworks]

Hello, everyone. .
how can I put the properties into the table automatically. . .
I'll explain better.
1)- bubble - img. pos.1
if I insert in the bubble number part gives me a number... What is it?

2)- number of pieces -
Is there any way to get it inserted automatically? Where do you get the number of parts inserted in a set?

3)- weight tot.-
how can I make him calculate this value based on the mass property already inserted automatically?

I'm sure someone will give me the right answers!

thanks and good work

1) the bubble should be connected to a component. I don't understand your purpose.
2) parts are divided into separate materials. the amount of the axieme/part that is stacking directly in the sheet cannot be automatically inserted with standard swx. to do this I "mark" the drawing in the printing phase with the pdm, inserting besides the quantity the commit and the date of printing.
3) simply insert a "weight" property into the prototype file to which the property is valued.