tega1
Guest
Good morning to all, I have this problem:
I've got my part from which I've got my mold cavity set and 2 prints.
My problem is that once I do everything, if I change my original part because I change the 2 footprints I have to get into the assieme cavity regenerate and then open the fingerprints regenerate these too and here I make the change.
Is my question not possible to automatically regenerate everything?
Thank you.
Say hi.
Faithful
I've got my part from which I've got my mold cavity set and 2 prints.
My problem is that once I do everything, if I change my original part because I change the 2 footprints I have to get into the assieme cavity regenerate and then open the fingerprints regenerate these too and here I make the change.
Is my question not possible to automatically regenerate everything?
Thank you.
Say hi.
Faithful