autonomous designs and flat repetition

[SimoneCRV]

Good morning,
in the office we are setting various tables of autonomous drawings (see qui example).
for who used it or knows how it works, I wondered it is possible to automate even the view of flat repetition?

Thank you.

 

[MassiVonWeizen]

What does the autonomous drawing mode have to do with creating a view?

the autonomous design mode, as explained in the guide, serves to use a design without having to load the model; therefore saving resources and allowing you to open the design even without the presence of the part file or together.

 

[SimoneCRV]

What does the autonomous drawing mode have to do with creating a view?

the autonomous design mode, as explained in the guide, serves to use a design without having to load the model; therefore saving resources and allowing you to open the design even without the presence of the part file or together.

to speed up the creation of the tables.
autonomous design has empty views. when on one side you make "create table", select the template design autonomous and find yourself, for example, already the 3 views placed on the table, part 3d.
and with another 2 clicks, on "model elements", you already have quotas at the table.
is not a little thing, especially for the plate of the piff, various angle type, tabs etc...
even it was something a little more elaborate, but it still leaves with a base already made. where you just need to cool.

 

[SimoneCRV]

What does the autonomous drawing mode have to do with creating a view?

the autonomous design mode, as explained in the guide, serves to use a design without having to load the model; therefore saving resources and allowing you to open the design even without the presence of the part file or together.

Anyway, you're right that it doesn't have to do directly with the creation seen, you can do quietly even with a normal design.
Anyway, I would need to know if it was possible to have an empty view of the flat repetition for an automatic drawing template.

Thank you.

 

[jenuary]

I think you just put in a view pointing to a file that contains a solid dot, so that you do not see in the drawing (empty look). then when you need to change the point of view to the file you want. You have to try

 

[SimoneCRV]

I think you just put in a view pointing to a file that contains a solid dot, so that you do not see in the drawing (empty look). then when you need to change the point of view to the file you want. You have to try

I tried, but unfortunately the model of the table, during the rescue does not admit external references. the views must all be empty and not point at all.

So I am thinking of integrating the table model with empty views, to a macro that adds me the view of flat repetition and "already you are there (cit.)", also the table of the cut distinction.