bend development sheet

[leggera]

Hello.

in my work are provided to me developments of plates and drawing of the same in 2d with the various folds to do.
Is there a function that allows me to fold the sheet, without the fold lines and consequently using the crease function?

in a few words I would like a function that makes me the various folds leaving the svuluppo unchanged.

Thank you.

 

[MassiVonWeizen]

You can't bend without telling him where he has to.
designs the developed model, drawings the fold lines, which on a 2d design there should be otherwise as the supplier produces it?, and use the bending function with sketch

 

[leggera]

Maybe I explained badly.
If I have a flattened piece of 100 and tell him to make me a flange of 15 mm this measure must be removed from the flat plate and me flange.
I would like to have a flat part of 85 mm and a flange of 15 mm .

 

[MassiVonWeizen]

I don't understand.
models development, draw a sketch line where it has to stand the fold and do the fold function by sketch setting the appropriate options

 

[leggera]

I don't want to put the sketch line I always have to change and adapt

 

[xxfast]

What you ask doesn't even exist in the casket.
You have to do the sketch and then insert the fold.

 

[MassiVonWeizen]

look that without reference cannot invent any bending.
between managing a sketch line and a possible setting of a function (which does not exist) the difference is nothing