"bombed" radius

[Olan]

hello to all are new in the forum,
I write you so that I hope you can give me a hand, I have to draw the surface (often 2mm) of fitting that you see in the photo. I realize that it doesn't have to be a very difficult thing for those who have a little hand but unfortunately I have experience for more purely mechanical designs than design... among other things I also have to "bomb", excuse the untechnical term, the radius and then I have to "crash the 3 ends... I use solidworks and rhino.

Thank you.

 

[MassiVonWeizen]

Do you want to do it with solidworks or rhinoceros? I don't think programs have the same procedures to get that corner.
more than design it is about knowing the program you use, even in carpentry do magnets or carter shaped and folded.
in solid you can try with a loft with a guide curve, but also a sweep or partial revolution could be enough or exploit the structural members. this to the nose because I do not have the program underhand; but at least you have four potential methods.

 

[Olan]

I tend to use solidworks I know better..thank you for advice, now I try to do something.
The problem is I only have a few days. .

I want to point out that I don't just have to close the corner but the chord surmounts the profiles

 

[Olan]

View attachment 38095loft made but it is not the result I look for, missing the bombing, the extension and the area s