bushing configuration with blind thread

[simone03031986]

Hi.
as from title I have this problem, I explain better: I have to produce a bushing with blind threaded hole that is deep up to a tot from the opposite face from which the hole begins. of this bushing I must create different configurations in which only the length of the same varies.
I tried both with the actual modeling, and with the guided creation of the holes. in the latter I found the possibility to create the pre-hole with the "offset of the surface" function, but not for the thread.

Can you help me?
Thank you, simone

 

[eboss]

then the hole always remains same size and changes the "depth" of the bushing or even threading?
attach the piece so if I can give it a given eye you have 2012.

 

[simone03031986]

the threaded hole always remains a m3, with a depth ( drilling and threading) that reaches a certain distance from the head of the bushing.
I attach the file

 

[erik.bo]

if you enter the thread sketch and the logos to the final face of the bushing with a fixed quota, placing the thread depth guided?
should work, unless the wizard function does not accept it.

 

[Ivan1990]

the threaded hole always remains a m3, with a depth ( drilling and threading) that reaches a certain distance from the head of the bushing.
I attach the file

If you create other configurations and right click on the sketch or function where you have the length quota, configure function, exit a tabellina above in the columns there is the name of the function or sketch you are configuring, and there is a freckle that goes on the low selections that, and then you will have a small window with the ability to flag, depending on what you put the flag, exit the corresponding quota to this flag that you can go to change.

 

[simone03031986]

In fact, I didn't realize that the creation led holes generated sketches. However, only the hole can be changed, which I managed by the feature manager. selecting "modification" in the thread sketch, no line appears to me.. .
Besides, I activated the visualization of the cosmetic thread that I see in the work area, but to see it in the rendering I have to activate something else?

 

[Mike1967]

In fact, I didn't realize that the creation led holes generated sketches. However, only the hole can be changed, which I managed by the feature manager. selecting "modification" in the thread sketch, no line appears to me.. .
Besides, I activated the visualization of the cosmetic thread that I see in the work area, but to see it in the rendering I have to activate something else?

read more qui there is "bibbia" of the cosmetic thread...:biggrin:

 

[simone03031986]

but if I generate the thread for modeling and drawing a very long spiral, is there no way to finish the extrusion of the triangle to a tot from the face? Does it have to end at the end of the spiral?